HDZero Whoop V2 Bundle(With Nano V3 Camera)

Notice: It uses HDZero digital protocol, only compatible with FrSky TANDEM X20 HD Transmitter or HDZERO receiver.

Description:
Whoop V2 VTX Specification:
Supported Cameras: All HDZero MIPI cams
Video Resolution: 720p60 / 540p90 / 1080p30
RF Power Output: 25 mW / 200 mW
Frequency Range: 5.725 – 5.850 GHz
RF Connector: Secured U.FL with brass bar
Video Connector: MIPI
Durability / PCB: Thicker PCB for impact resistance
Wiring / Install: Pre-soldered wire harness
Size: 31 × 31 mm (29 × 29 inner)
Mounting Pattern: 25.5 × 25.5 mm (M2)
Weight: 5.4 g (5.1 g w/o wires)
Board Thickness: ~1.6 mm
Power Input: 3 – 12.6 V (1S – 3S)
Power Consumption: 5 – 6 W
Control / OSD: MSP OSD / Smart Audio
Recommended Use: 80 mm whoops – 4″ micro drones
Mounting Hardware: M2 grommets + brass bar included
Antenna Included: Not included
Alternative for Ultralight Builds: HDZero AIO (FC + VTX, AHD interface)

Nano V3 Camera Specification:
Size:14x16x14mm
Weight:2.2gram
Sensor:0.5 inch, up to 10650 mV/Lux-sec
           Ultra-high sensitive CMOS sensor
FOV:FOV D:155° H:126° V:94°

Package Included:
HDZero Whoop V2 VTX * 1;
HDZero Nano V3 Camera * 1;
Dipole Antenna * 1;
40mm Mipi Cable * 1；
Rubber Grommet (M3 to M2) * 4;
u.FL Antenna Retention Screws * 3;
Metal bar * 1